Radiogenic noble gases are contained in crustal rock at inter and intra granular sites. The gas composition depends on lithology, geologic history, fluid phases, and the aging effect by decay of U, Th, and K. The isotopic signature of noble gases found in rocks is vastly different than that of the atmosphere which is contributed by a variety of sources. When rock is subjected to stress conditions exceeding about half its yield strength, micro-cracks begin to form. As rock deformation progresses a fracture network evolves, releasing trapped noble gases and changing the transport properties to gas migration. Thus, changes in gas emanation and noble gas composition from rocks could be used to infer changes in stress-state and deformation. The purpose of this study has been to evaluate the effect of deformation/strain rate upon noble gas release. Four triaxial experiments were attempted for a strain rate range of %7E10-8 /s (180,000s) to %7E 10-4/s (500s); the three fully successful experiments (at the faster strain rates) imply the following: (1) helium is measurably released for all strain rates during deformation, this release is in amounts 1-2 orders of magnitude greater than that present in the air, and (2) helium gas release increases with decreasing strain rate.
A series of constant mean stress (CMS) and constant shear stress (CSS) tests were performed to investigate the evolution of permeability and Biot coefficient at high mean stresses in a high porosity reservoir analog (Castlegate sandstone). Permeability decreases as expected with increasing mean stress, from about 20 Darcy at the beginning of the tests to between 1.5 and 0.3 Darcy at the end of the tests (mean stresses up to 275 MPa). The application of shear stress causes permeability to drop below that of a hydrostatic test at the same mean stress. Results show a nearly constant rate decrease in the Biot coefficient as the mean stress increases during hydrostatic loading, and as the shear stress increases during CMS loading. CSS tests show a stabilization of the Biot coefficient after the application of shear stress.
Gas permeability measurements have been made on granular samples during consolidation under hydrostatic stresses up to 40 MPa and temperatures up to 250 °C. The initial porosity of the samples prior to consolidation was as great as 0.40; depending on the test conditions and duration, the resulting final porosity was between 0.08 and less than 0.01. Although these tests were conducted at different temperatures, pressures, durations and salt types, a similar reduction in permeability was observed. The permeability steadily decreased from the initial relatively large value around 10-14 m2 until after some critical porosity is reached (between 0.02 to 0.05); below the critical porosity, the permeability decreased at an increased rate. This response is attributed to loss of pore connectivity within the consolidating salt sample. The data suggest a very low porosity will have to be reached before the permeability of consolidating granular salt will be comparable to intact salt for conditions considered here.
Natural gas storage facilities are a critical component of our energy supply and distribution chain, allowing elasticity in gas supply to accommodate daily to seasonal demand fluctuations. As has been made evident by the recent Aliso Canyon Gas Storage facility incident, a loss of well integrity may result in significant consequences, including the prolonged shutdown of an entire facility. The Aliso Canyon gas well blowout emitted approximately 100,000 tonnes of natural gas (mostly methane) over 4 months and displaced thousands of nearby residents from their homes. The high visibility of the event has led to increased scrutiny of the safety of natural gas storage at the Aliso Canyon facility, led to questions about energy reliability, and raised broader concerns for natural gas storage integrity throughout the country.
Deep Borehole Disposal (DBD) of high-level radioactive wastes has been considered an option for geological isolation for many years (Hess et al. 1957). Recent advances in drilling technology have decreased costs and increased reliability for large-diameter (i.e., ≥50 cm [19.7”]) boreholes to depths of several kilometers (Beswick 2008; Beswick et al. 2014). These advances have therefore also increased the feasibility of the DBD concept (Brady et al. 2009; Cornwall 2015), and the current field test design will demonstrate the DBD concept and these advances. The US Department of Energy (DOE) Strategy for the Management and Disposal of Used Nuclear Fuel and High-Level Radioactive Waste (DOE 2013) specifically recommended developing a research and development plan for DBD. DOE sought input or expression of interest from States, local communities, individuals, private groups, academia, or any other stakeholders willing to host a Deep Borehole Field Test (DBFT). The DBFT includes drilling two boreholes nominally 200m [656’] apart to approximately 5 km [16,400’] total depth, in a region where crystalline basement is expected to begin at less than 2 km depth [6,560’]. The characterization borehole (CB) is the smaller-diameter borehole (i.e., 21.6 cm [8.5”] diameter at total depth), and will be drilled first. The geologic, hydrogeologic, geochemical, geomechanical and thermal testing will take place in the CB. The field test borehole (FTB) is the larger-diameter borehole (i.e., 43.2 cm [17”] diameter at total depth). Surface handling and borehole emplacement of test package will be demonstrated using the FTB to evaluate engineering feasibility and safety of disposal operations (SNL 2016).
The 2015-2016 Aliso Canyon/Porter Ranch natural gas well blowout emitted approximately 100,000 tonnes of natural gas (mostly methane, CH4) over four months. The blowout impacted thousands of nearby residents, who were displaced from their homes. The high visibility of the event has led to increased scrutiny of the safety of natural gas storage at the Aliso Canyon facility, as well as broader concern for natural gas storage integrity throughout the country. This report presents the findings of the DOE National Laboratories Well Integrity Work Group efforts in the four tasks. In addition to documenting the work of the Work Group, this report presents high priority recommendations to improve well integrity and reduce the likelihood and consequences of subsurface natural gas leaks.
The Mount Simon Sandstone and Eau Claire Formation represent a potential reservoir-caprock system for wastewater disposal, geologic CO2 storage, and compressed air energy storage (CAES) in the Midwestern United States. A primary concern to site performance is heterogeneity in rock properties that could lead to nonideal injectivity and distribution of injected fluids (e.g., poor sweep efficiency). Using core samples from the Dallas Center domal structure, Iowa, we investigate pore characteristics that govern flow properties of major lithofacies of these formations. Methods include gas porosimetry and permeametry, mercury intrusion porosimetry, thin section petrography, and X-ray diffraction. The lithofacies exhibit highly variable intraformational and interformational distributions of pore throat and body sizes. Based on pore-throat size, there are four distinct sample groups. Micropore-throat-dominated samples are from the Eau Claire Formation, whereas the macropore-dominated, mesopore-dominated, and uniform-dominated samples are from the Mount Simon Sandstone. Complex paragenesis governs the high degree of pore and pore-throat size heterogeneity, due to an interplay of precipitation, nonuniform compaction, and later dissolution of cements. The cement dissolution event probably accounts for much of the current porosity in the unit. Mercury intrusion porosimetry data demonstrate that the heterogeneous nature of the pore networks in the Mount Simon Sandstone results in a greater than normal opportunity for reservoir capillary trapping of nonwetting fluids, as quantified by CO2 and air column heights that vary over three orders of magnitude, which should be taken into account when assessing the potential of the reservoir-caprock system for waste disposal (CO2 or produced water) and resource storage (natural gas and compressed air). Our study quantitatively demonstrates the significant impact of millimeter-scale to micron-scale porosity heterogeneity on flow and transport in reservoir sandstones.
The objective of this research is to produce laboratory-based experimental and numerical analysis that will provide a physics-based understanding of shear stimulation phenomena (hydroshearing) and its evolution during stimulation. Water is flowed along fractures in hot and stressed fractured rock, to promote slip. The controlled laboratory experiments potentially provide a high resolution/high quality data resource for evaluation of many analysis methods developed by to assess EGS "behavior" during this stimulation process. Segments of the experimental program provide data sets for model input parameters, i.e., material properties, and other segments of the experimental program represent small scale physical models of an EGS system, which may be modeled. The project is a study of the response of a fracture in hot, water-saturated fractured rock to shear stress which is experiencing fluid flow. Under this condition, the fracture experiences a combination of potential pore pressure changes and fracture surface cooling, resulting in slip along the fracture. As such, the work provides a means to assess the role of "hydroshearing" on permeability enhancement in reservoir stimulation. Using the laboratory experiments and modeling, including pore pressure, thermal stress, fracture shear deformation, and fluid flow, insight into the role of fracture slip on permeability enhancement-"hydro-shear" is obtained. This paper presents the results of an experimental program along with numerical modeling to study shear stimulation of fractures in response to cool water injection into hot stressed rock with simulated fractures. Laboratory-based experimental and numerical analysis results are used to provide a physics-based understanding of shear stimulation phenomena (hydroshearing) and its evolution during stimulation. In order to study hydroshearing in the laboratory, a test system has been configured to (1) simulate reasonable downhole EGS environmental conditions, (2) flow cool water along fractures in hot and stressed fractured rock, (3) from (2) promote slip, (4) model the experiments in a tractable manner such that insight may be obtained of slip mechanisms. Thermo-poroelastic finite element analysis of a fractured rock injection experiment has been carried out to explore the role of pore pressure, cooling and coupled processes on fracture deformation and slip. Good agreement between numerical modeling and experimental observations is achieved. Simulation results illustrate that pore pressure and cooling cause the fracture system to deform (slip) resulting in permeability modifications. Fracture permeability evolution with stress variations in the sample is also observed in these experiments.
Seven water-saturated triaxial extension experiments were conducted on four sedimentary rocks. This experimental condition was hypothesized more representative of that existing for downhole hydrofracture and thus it may improve our understanding of the phenomena. In all tests the pore pressure was 10 MPa and confirming pressure was adjusted to achieve tensile and transitional failure mode conditions. Using previous work in this LDRD for comparison, the law of effective stress is demonstrated in extension using this sample geometry. In three of the four lithologies, no apparent chemo-mechanical effect of water is apparent, and in the fourth lithology test results indicate some chemo-mechanical effect of water.
This report presents efforts to develop the use of in situ naturally-occurring noble gas tracers to evaluate transport mechanisms and deformation in shale hydrocarbon reservoirs. Noble gases are promising as shale reservoir diagnostic tools due to their sensitivity of transport to: shale pore structure; phase partitioning between groundwater, liquid, and gaseous hydrocarbons; and deformation from hydraulic fracturing. Approximately 1.5-year time-series of wellhead fluid samples were collected from two hydraulically-fractured wells. The noble gas compositions and isotopes suggest a strong signature of atmospheric contribution to the noble gases that mix with deep, old reservoir fluids. Complex mixing and transport of fracturing fluid and reservoir fluids occurs during production. Real-time laboratory measurements were performed on triaxially-deforming shale samples to link deformation behavior, transport, and gas tracer signatures. Finally, we present improved methods for production forecasts that borrow statistical strength from production data of nearby wells to reduce uncertainty in the forecasts.