Publications

Abstract not provided.

Abstract not provided.

Abstract not provided.

Nanofiltration (NF) can effectively treat cooling-tower water to reduce water consumption and maximize water usage efficiency of thermoelectric power plants. A pilot is being run to verify theoretical calculations. A side stream of water from a 900 gpm cooling tower is being treated by NF with the permeate returning to the cooling tower and the concentrate being discharged. The membrane efficiency is as high as over 50%. Salt rejection ranges from 77-97% with higher rejection for divalent ions. The pilot has demonstrated a reduction of makeup water of almost 20% and a reduction of discharge of over 50%.

Abstract not provided.

Abstract not provided.

Abstract not provided.

Abstract not provided.

Sandia National Laboratories (SNL) is conducting pilot scale evaluations of the performance and cost of innovative water treatment technologies aimed at meeting the recently revised arsenic maximum contaminant level (MCL) for drinking water. The standard of 10 {micro}g/L (10 ppb) is effective as of January 2006. The pilot tests have been conducted in New Mexico where over 90 sites that exceed the new MCL have been identified by the New Mexico Environment Department. The pilot test described in this report was conducted in Anthony, New Mexico between August 2005 and December 2006 at Desert Sands Mutual Domestic Water Consumers Association (MDWCA) (Desert Sands) Well No.3. The pilot demonstrations are a part of the Arsenic Water Technology Partnership program, a partnership between the American Water Works Association Research Foundation (AwwaRF), SNL and WERC (A Consortium for Environmental Education and Technology Development). The Sandia National Laboratories pilot demonstration at the Desert Sands site obtained arsenic removal performance data for fourteen different adsorptive media under intermittent flow conditions. Well water at Desert Sands has approximately 20 ppb arsenic in the unoxidized (arsenite-As(III)) redox state with moderately high total dissolved solids (TDS), mainly due to high sulfate, chloride, and varying concentrations of iron. The water is slightly alkaline with a pH near 8. The study provides estimates of the capacity (bed volumes until breakthrough at 10 ppb arsenic) of adsorptive media in the same chlorinated water. Adsorptive media were compared side-by-side in ambient pH water with intermittent flow operation. This pilot is broken down into four phases, which occurred sequentially, however the phases overlapped in most cases.

Abstract not provided.

Sandia National Laboratories (SNL) is conducting pilot scale evaluations of the performance and cost of innovative water treatment technologies aimed at meeting the recently revised arsenic maximum contaminant level (MCL) for drinking water. The standard of 10 {micro}g/L (10 ppb) is effective as of January 2006. The first pilot tests have been conducted in New Mexico where over 90 sites that exceed the new MCL have been identified by the New Mexico Environment Department. The pilot test described in this report was conducted in Socorro New Mexico between January 2005 and July 2005. The pilot demonstration is a project of the Arsenic Water Technology Partnership program, a partnership between the American Water Works Association Research Foundation (AwwaRF), SNL and WERC (A Consortium for Environmental Education and Technology Development). The Sandia National Laboratories pilot demonstration at the Socorro Springs site obtained arsenic removal performance data for five different adsorptive media under constant ambient flow conditions. Well water at Socorro Springs has approximately 42 ppb arsenic in the oxidized (arsenate-As(V)) redox state with moderate amounts of silica, low concentrations of iron and manganese and a slightly alkaline pH (8). The study provides estimates of the capacity (bed volumes until breakthrough at 10 ppb arsenic) of adsorptive media in the same chlorinated water. Near the end of the test the feedwater pH was lowered to assess the affect on bed capacity and as a prelude to a controlled pH study (Socorro Springs Phase 2).

Abstract not provided.

The lowering of the drinking water standard (MCL) for arsenic from 50 {micro}g/L to 10 {micro}g/L in January 2006 could lead to significant increases in the cost of water for many rural systems throughout the United States. The Arsenic Water Technology Partnership (AWTP), a collaborative effort of Sandia National Laboratories, the Awwa Research Foundation (AwwaRF) and WERC: A Consortium for Environmental Education and Technology Development, was formed to address this problem by developing and testing novel treatment technologies that could potentially reduce the costs of arsenic treatment. As a member of the AWTP, Sandia National Laboratories evaluated cutting-edge commercial products in three annual Arsenic Treatment Technology Vendors Forums held during the annual New Mexico Environmental Health Conferences (NMEHC) in 2003, 2004 and 2005. The Forums were comprised of two parts. At the first session, open to all conference attendees, commercial developers of innovative treatment technologies gave 15-minute talks that described project histories demonstrating the effectiveness of their products. During the second part, these same technologies were evaluated and ranked in closed sessions by independent technical experts for possible use in pilot-scale field demonstrations being conducted by Sandia National Laboratories. The results of the evaluations including numerical rankings of the products, links to company websites and copies of presentations made by the representatives of the companies are posted on the project website at http://www.sandia.gov/water/arsenic.htm. This report summarizes the contents of the website by providing brief descriptions of the technologies represented at the Forums and the results of the evaluations.

Abstract not provided.

Sandia National Laboratories (SNL) is conducting pilot scale evaluations of the performance and cost of innovative drinking water treatment technologies designed to meet the new arsenic maximum contaminant level (MCL) of 10 {micro}g/L (effective January 2006). As currently envisioned, pilots tests may include multiple phases. Phase I tests will involve side-by-side comparisons of several commercial technologies primarily using design parameters suggested by the Vendors. Subsequent tests (Phase II) may involve repeating some of the original tests, testing the same commercial technologies under different conditions and testing experimental technologies or additional commercial technologies. This Pilot Test Specific Test Plan (PTSTP) was written for Phase I of the Socorro Springs Pilot. The objectives of Phase I include evaluation of the treatment performance of five adsorptive media under ambient pH conditions (approximately 8.0) and assessment of the effect of contact time on the performance of one of the media. Addenda to the PTSTP may be written to cover Phase II studies and supporting laboratory studies. The Phase I demonstration began in the winter of 2004 and will last approximately 9 months. The information from the test will help the City of Socorro choose the best arsenic treatment technology for the Socorro Springs well. The pilot demonstration is a project of the Arsenic Water Technology Partnership program, a partnership between the American Water Works Association (AWWA) Research Foundation, SNL, and WERC (A Consortium for Environmental Education and Technology Development).

Abstract not provided.

Abstract not provided.

Abstract not provided.

Abstract not provided.

Abstract not provided.

The Arsenic Water Technology Partnership program is a multi-year program funded by a congressional appropriation through the Department of Energy. The program is designed to move technologies from benchscale tests to field demonstrations. It will enable water utilities, particularly those serving small, rural communities and Indian tribes, to implement the most cost-effective solutions to their arsenic treatment needs. As part of the Arsenic Water Technology Partnership program, Sandia National Laboratories is carrying out field demonstration testing of innovative technologies that have the potential to substantially reduce the costs associated with arsenic removal from drinking water. The scope for this work includes: (1) Selection of sites and identification of technologies for pilot demonstrations; (2) Laboratory studies to develop rapid small-scale test methods; and (3) Pilot-scale studies at community sites involving side-by-side tests of innovative technologies. The goal of site selection is to identify sites that allow examination of treatment processes and systems under conditions that are relevant to different geochemical settings throughout the country. A number of candidate sites have been identified through reviews of groundwater quality databases, conference proceedings and discussions with state and local officials. These include sites in New Mexico, Arizona, Colorado, Oklahoma, Michigan, and California. Candidate technologies for the pilot tests are being reviewed through vendor forums, proof-of-principle benchscale studies managed by the American Water Works Association Research Foundation (AwwaRF) and the WERC design contest. The review considers as many potential technologies as possible and screens out unsuitable ones by considering data from past performance testing, expected costs, complexity of operation and maturity of the technology. The pilot test configurations will depend on the site-specific conditions such as access, power availability, waste disposal options and availability of permanent structures to house the test. Conducting pilot tests for media comparison at all sites in need of arsenic treatment would be extremely time consuming and costly. Laboratory studies are being conducted using rapid small-scale column tests (RSSCTs) to predict the performance of pilot-scale adsorption columns. RSSCTs are a rapid and inexpensive method of investigating innovative technologies while varying water quality and/or system design. RSSCTs are scaled down columns packed with smaller diameter adsorption media that receive higher hydraulic loading rates to significantly reduce the duration of experiments. Results for RSSCTs can be obtained in a matter of days to a few weeks, whereas pilot tests can take a number of months to over a year. In the pilot tests, the innovative technologies will be evaluated in terms of adsorptive capacity for arsenic; robustness of performance with respect to water quality parameters including pH, TDS, foulants such as Fe, Mn, silica, and organics, and other metals and radionuclides; and potentially deleterious effects on the water system such as pipe corrosion from low pH levels, fluoride removal, and generation of disinfection by-products. The new arsenic MCL will result in modification of many rural water systems that otherwise would not require treatment. Simultaneous improvement of water quality in systems that will require treatment for other contaminants such as uranium, radon and radium would be an added benefit of this program.

As part of the Arsenic Water Technology Partnership program, Sandia National Laboratories will carry out field demonstration testing of innovative technologies that have the potential to substantially reduce the costs associated with arsenic removal from drinking water. The scope for this work includes: (1) selection of sites for pilot demonstrations, (2) identification of candidate technologies through Vendor Forums, proof-of-principle bench-scale studies managed by the American Water Works Association Research Foundation (AwwaRF) or the WERC design contest, and (3) pilot-scale studies involving side-by-side tests of innovative technologies. The goal of site selection is identification of a suite of sites that exhibit a sufficiently wide range of groundwater chemistries to allow examination of treatment processes and systems under conditions that are relevant to different geochemical settings throughout the country. A number of candidate sites have been identified through reviews of groundwater quality databases, conference proceedings and discussions with state and local officials. These include sites in New Mexico, Arizona, Colorado, Oklahoma, Illinois, Michigan, Florida, Massachusetts and New Hampshire. In New Mexico, discussions have been held with water utility board staffs in Chama, Jemez Pueblo, Placitas, Socorro and several communities near Las Cruces to determine the suitability of those communities for pilot studies. The initial pilot studies will be carried at Socorro and Jemez Pueblo; other communities will be included as the program progresses. The proposed pilot test at a hot spring water source near Socorro will provide an opportunity to test treatment technologies at relatively high temperatures. If approved by the Tribal Government, the proposed pilot at the Jemez Pueblo would provide an opportunity to test technologies that will remove arsenic in the presence of relatively high concentrations of iron and manganese while leaving the beneficial levels of fluoride unchanged. Candidate technologies for the pilot tests are being reviewed by technical evaluation teams. The initial reviews will consider as many potential technologies and screen out unsuitable ones by considering data from past performance testing, expected costs, complexity of operation and maturity of the technology. The pilot test configurations will depend on the site-specific conditions such as access, power availability, waste disposal options and availability of permanent structures to house the test. Most of the treatment technologies that will be evaluated can be separated into two broad categories: (1) sorption processes that use fixed bed adsorbents and (2) membrane processes. The latter include processes that involve formation of a floc or precipitate that contains the arsenic in a reactor followed by separation of the solids from the water by filtration. Several innovations that could lead to lower treatment costs have been proposed for adsorptive media systems. These include: (1) higher capacity and selectivity using mixed oxides composed of iron and other transition metals, titanium and zirconium based oxides, or mixed resin-metal oxides composite media, (2) improved durability of virgin media and greater chemical stability of the spent media, and (3) use of inexpensive natural or recycled materials with a coating that has a high affinity for arsenic. Improvements to filtration-based treatment systems include: (1) enhanced coagulation with iron compounds or polyelectrolytes and (2) improved filtration with nanocomposite materials. In the pilot tests, the innovative technologies will be evaluated in terms of: (1) their ability to reduce arsenic to levels below the EPA Maximum Contaminant Level (MCL) of 10 ppb, (2) site-specific adsorptive capacity, robustness of performance with respect to likely changes in water quality parameters including pH, TDS, foulants such as Fe, Mn, silica, and organics, effect of competing ions such as other metals and radionuclides, and potentially deleterious effects on the water system such as pipe corrosion from low pH levels, fluoride removal, and generation of disinfection by-products. The new arsenic MCL will result in modification of many rural water systems that otherwise would not require treatment. Opportunities for improvement of water quality in systems that currently do not comply with other standards would be an added benefit from the new arsenic MCL that has both economic and public health value.