Battery cells with metal casings are commonly considered incompatible with nuclear magnetic resonance (NMR) spectroscopy because the oscillating radio-frequency magnetic fields ("rf fields") responsible for excitation and detection of NMR active nuclei do not penetrate metals. Here, we show that rf fields can still efficiently penetrate nonmetallic layers of coin cells with metal casings provided "B1 damming"configurations are avoided. With this understanding, we demonstrate noninvasive high-field in situ 7Li and 19F NMR of coin cells with metal casings using a traditional external NMR coil. This includes the first NMR measurements of an unmodified commercial off-the-shelf rechargeable battery in operando, from which we detect, resolve, and separate 7Li NMR signals from elemental Li, anodic β-LiAl, and cathodic LixMnO2 compounds. Real-time changes of β-LiAl lithium diffusion rates and variable β-LiAl 7Li NMR Knight shifts are observed and tied to electrochemically driven changes of the β-LiAl defect structure.
In the subsurface, MgO engineered barriers are employed at the Waste Isolation Pilot Plant (WIPP), a transuranic waste repository near Carlsbad, NM. During service, the MgO will be exposed to high concentration brine environments and may form stable intermediate phases that can alter the barriers effectiveness. Here, MgO was aged in water and three different brine solutions. X-ray diffraction (XRD) and 1H nuclear magnetic resonance (NMR) analysis were performed to identify the formation of secondary phases. After aging, ~4% of the MgO was hydrated and fine-grained powders resulted in greater loss of crystallinity than hard granular grains. 1H magic angle spinning (MAS) NMR spectra resolved minor phases not visible in XRD, indicating that diverse 1H environments are present along with Mg(OH)2. Density functional theory (DFT) simulations for several proposed Mg-O-H, Mg-CI-O-H, and Na-O-H containing phases were performed to index peaks in the experimental 1H MAS NMR spectra. While proposed intermediate crystal structures exhibited overlapping 1H NMR peaks, Mg-O-H intermediates were attributed to the growth of the 1.0-0.0ppm peak while the Mg-CI-O-H structures contributed to the 2.5- 5.0ppm peak in the chloride containing brines. Overall, NMR analysis of aged MgO indicates the formation of a range of possible intermediate structures that cannot be resolved with XRD analysis alone.
Magnesium oxide (MgO) can convert to different magnesium-containing compounds depending on exposure and environmental conditions. Many MgO-based phases contain hydrated species allowing 1H-nuclear magnetic resonance (NMR) spectroscopy to be used in the characterization and quantification of proton-containing phases; however, surprisingly limited examples have been reported. Here, 1H-magic angle spinning (MAS) NMR spectra of select Mg-based minerals are presented and assigned. These experimental results are combined with computational NMR density functional theory (DFT) periodic calculations to calibrate the predicted chemical shielding results. This correlation is then used to predict the NMR shielding for a series of different MgO hydroxide, magnesium chloride hydrate, magnesium perchlorate, and magnesium cement compounds to aid in the future assignment of 1H-NMR spectra for complex Mg phases.
Nuclear magnetic resonance (NMR) spin diffusion measurements have been widely used to estimate domain sizes in a variety of polymer materials. In cases where the domains are well-described as regular, repeating structures (e.g., lamellar, cylindrical channels, monodispersed spherical domains), the domain sizes estimated from NMR spin diffusion experiments agree with the characteristic length scales obtained from small-angle x-ray scattering and microscopy. In our laboratory, recent NMR spin diffusion experiments for hydrated sulfonated Diels Alder poly(phenylene) (SDAPP) polymer membranes have revealed that assuming a simple structural model can often misrepresent or overestimate the domain size in situations where more complex and disordered morphologies exist. Molecular dynamics simulations of the SDAPP membranes predict a complex heterogeneous hydrophilic domain structure that varies with the degree of sulfonation and hydration and is not readily represented by a simple repeating domain structure. This heterogeneous morphology results in NMR-measured domain sizes that disagree with length scales estimated from the ionomer peak in scattering experiments. Here we present numerical NMR spin diffusion simulations that show how structural disorder in the form of domain size distributions or domain clustering can significantly impact the spin diffusion analysis and estimated domain sizes. Simulations of NMR spin diffusion with differing domain size distributions and domain clustering are used to identify the impact of the heterogeneous domain structure and highlight the limitations of using NMR spin diffusion techniques for irregular structures.
Multiple computational and experimental techniques are used to understand the nanoscale morphology and water/proton transport properties in a series of sulfonated Diels-Alder poly(phenylene) (SDAPP) membranes over a wide range of temperature, hydration, and sulfonation conditions. New synthetic methods allow us to sulfonate the SDAPP membranes to much higher ion exchange capacity levels than has been previously possible. Nanoscale phase separation between the hydrophobic polymer backbone and the hydrophilic water/sulfonic acid groups was observed for all membranes studied. We find good agreement between structure factors calculated from atomistic molecular dynamics (MD) simulations and those measured by X-ray scattering. With increasing hydration, the scattering ionomer peak in SDAPP is found to decrease in intensity. This intensity decrease is shown to be due to a reduction of scattering contrast between the water and polymer and is not indicative of any loss of nanoscale phase separation. Both MD simulations and density functional theory (DFT) calculations show that as hydration levels are increased, the nanostructure morphology in SDAPP evolves from isolated ionic domains to fully percolated water networks containing progressively weaker hydrogen bond strengths. The conductivity of the membranes is measured by electrical impedance spectroscopy and the equivalent proton conductivity calculated from pulsed-field-gradient (PFG) NMR diffusometry measurements of the hydration waters. Comparison of the measured and calculated conductivity reveals that in SDAPP the proton conduction mechanism evolves from being dominated by vehicular transport at low hydration and sulfonation levels to including a significant contribution from the Grötthuss mechanism (also known as structural diffusion) at higher hydration and sulfonation levels. The observed increase in conductivity reflects the impact that changing hydration and sulfonation have on the morphology and hydrogen bond network and ultimately on the membrane performance.
Magnesium oxide (MgO)-engineered barriers used in subsurface applications will be exposed to high concentration brine environments and may form stable intermediate phases that can alter the effectiveness of the barrier. To explore the formation of these secondary intermediate phases, MgO was aged in water and three different brine solutions and characterized with X-ray diffraction (XRD) and 1H magic angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopy. After aging, there is ∼4% molar equivalent of a hydrogen-containing species formed. The 1H MAS NMR spectra resolved multiple minor phases not visible in XRD, indicating that diverse disordered proton-containing environments are present in addition to crystalline Mg(OH)2 brucite. Density functional theory (DFT) simulations for the proposed Mg-O-H-, Mg-Cl-O-H-, and Na-O-H-containing phases were performed to index resonances observed in the experimental 1H MAS NMR spectra. Although the intermediate crystal structures exhibited overlapping 1H NMR resonances in the spectra, Mg-O-H intermediates were attributed to the growth of resonances in the δ +1.0 to 0.0 ppm region, and Mg-Cl-O-H structures produced the increasing contributions of the δ = +2.5 to 5.0 ppm resonances in the chloride-containing brines. Overall, 1H NMR analysis of aged MgO indicates the formation of a wide range of possible intermediate structures that cannot be observed or resolved in the XRD analysis.
The effects of ultra-low glass transition temperature (Tg) phosphate glass (Pglass) on the thermal, morphological, rheological, mechanical, and crystallization properties of hybrid Pglass/poly(eththylene terephthalate)(PET) were investigated. Nano- and micro-scale distribution of the Pglass in the PET polymer matrix was observed. The polydispersed Pglass in the PET matrix functioned as a nucleation agent, resulting in increasing crystallization temperature. The Pglass in the PET matrix decreased the Tg, indicating a plasticizing effect of the Pglass in the hybrids that was confirmed by the significantly decreased complex viscosity of the PET matrix. In addition, with increasing temperature, a non-terminal behavior of the viscoelastic properties occurred due to the hybrid structural changes and improved miscibility of the hybrid components. Further, the obtained solid-state variable temperature 31P and 1H NMR spectroscopy results showed strong Pglass concentration dependency of the interactions at the PET-Pglass interface.
Some long-outstanding technical challenges exist that continue to be of hindrance to fully harnessing the unique investigative advantages of nuclear magnetic resonance (NMR) spectroscopy in the in situ investigation of rechargeable battery chemistry. For instance, the conducting materials and circuitry necessary for an operational battery always deteriorate the coil-based NMR sensitivity when placed inside the coil, and the shape mismatch between them leads to low sample filling factors and even higher detection limits. We report, herein, a novel and successful adaptation of stripline NMR detection that integrates seamlessly NMR detection with the construction of an electrochemical device in general, or a battery in particular, which leads to an in situ electrochemical NMR technique with much higher detection sensitivity, higher sample filling factor, and which is particularly suitable for mass-limited samples.
Solid state NMR spectroscopy is inherently sensitive to chemical structure and composition and thus makes an ideal method to probe the heterogeneity of multicomponent polymers. Specifically, NMR spin diffusion experiments can be used to extract reliable information about spatial domain sizes on multiple length scales, provided that magnetization selection of one domain can be achieved. In this paper, we demonstrate the preferential filtering of protons in fluorinated domains during NMR spin diffusion experiments using 1H-19F heteronuclear dipolar dephasing based on rotational echo double resonance (REDOR) MAS NMR techniques. Three pulse sequence variations are demonstrated based on the different nuclei detected: direct 1H detection, plus both 1H➔13C cross polarization and 1H➔19F cross polarization detection schemes. This 1H-19F REDOR-filtered spin diffusion method was used to measure fluorinated domain sizes for a complex polymer blend. The efficacy of the REDOR-based spin filter does not rely on spin relaxation behavior or chemical shift differences and thus is applicable for performing NMR spin diffusion experiments in samples where traditional magnetization filters may prove unsuccessful. This REDOR-filtered NMR spin diffusion method can also be extended to other samples where a heteronuclear spin pair exists that is unique to the domain of interest.