It has been recognized that documentation for new customers of ASCI Red, aka janus or the Intel Teraflops at Sandia National Laboratories, has been sadly lacking. This document has been prepared by a team of subject matter experts to fill that void and to provide a starting point for providing a similar document for ASCI Red Storm in the future. This document is intended for SNL users who need to jumpstart their use of Janus and Janus-s.
Carbon is an important support for heterogeneous catalysts, such as platinum supported on activated carbon (AC). An important property of these catalysts is that they decompose upon heating in air. Consequently, Pt/AC catalysts can be used in applications requiring rapid decomposition of a material, leaving little residue. This report describes the catalytic effects of platinum on carbon decomposition in an attempt to maximize decomposition rates. Catalysts were prepared by impregnating the AC with two different Pt precursors, Pt(NH{sub 3}){sub 4}(NO{sub 3}){sub 2} and H{sub 2}PtCl{sub 6}. Some catalysts were treated in flowing N{sub 2} or H{sub 2} at elevated temperatures to decompose the Pt precursor. The catalysts were analyzed for weight loss in air at temperatures ranging from 375 to 450 C, using thermogravimetric analysis (TGA). The following results were obtained: (1) Pt/AC decomposes much faster than pure carbon; (2) treatment of the as-prepared 1% Pt/AC samples in N{sub 2} or H{sub 2} enhances decomposition; (3) autocatalytic behavior is observed for 1% Pt/AC samples at temperatures {ge} 425 C; (4) oxygen is needed for decomposition to occur. Overall, the Pt/AC catalyst with the highest activity was impregnated with H{sub 2}PtCl{sub 6} dissolved in acetone, and then treated in H{sub 2}. However, further research and development should produce a more active Pt/AC material.
Magnesium vanadates are potentially important catalytic materials for the conversion of alkanes to alkenes via oxidative dehydrogenation. However, little is known about the active sites at which the catalytic reactions take place. It may be possible to obtain a significant increase in the catalytic efficiency if the effects of certain material properties on the surface reactions could be quantified and optimized through the use of appropriate preparation techniques. Given that surface reactivity is often dependent upon surface structure and that the atomic level structure of the active sites in these catalysts is virtually unknown, we desire thin film samples consisting of a single magnesium vanadate phase and a well defined crystallographic orientation in order to reduce complexity and simplify the study of active sites. This report describes the use of reactive RF sputter deposition to fabricate very highly oriented, stoichiometric Mg{sub 3}(VO{sub 4}){sub 2} thin films, and subsequent studies of the reactivity of these films under reaction conditions typically found during oxidative dehydrogenation. We demonstrate that the synthesis methods employed do in fact result in stoichiometric films with the desired crystallographic orientation, and that the chemical behavior of the films closely approximates that of bulk, high surface area Mg{sub 3}(VO{sub 4}){sub 2} powders. We further use these films to demonstrate the effects of oxygen vacancies on chemical behavior, demonstrate that surface composition can vary significantly under reaction conditions, and obtain the first evidence for structure sensitivity in Mg{sub 3}(VO{sub 4}){sub 2} catalysts.
A new method to generate chemical reaction network is proposed. The particularity of the method is that network generation and mechanism reduction are performed simultaneously using sampling techniques. Our method is tested for hydrocarbon thermal cracking. Results and theoretical arguments demonstrate that our method scales in polynomial time while other deterministic network generators scale in exponential time. This finding offers the possibility of investigating complex reacting systems such as those studied in petroleum refining and combustion.