Publications

Hugoniot and strength behavior of silicon carbide

Vogler, Tracy V.; Reinhart, William D.; Chhabildas, Lalit C.

The shock behavior of two varieties of the ceramic silicon carbide was investigated through a series of time-resolved plate impact experiments reaching stresses of over 140 GPa. The Hugoniot data obtained are consistent for the two varieties tested as well as with most data from the literature. Through the use of reshock and release configurations, reloading and unloading responses for the material were found. Analysis of these responses provides a measure of the ceramic's strength behavior as quantified by the shear stress and the strength in the Hugoniot state. While previous strength measurements were limited to stresses of 20-25 GPa, measurements were made to 105 GPa in the current study. The initial unloading response is found to be elastic to stresses as high as 105 GPa, the level at which a solid-to-solid phase transformation is observed. While the unloading response lies significantly below the Hugoniot, the reloading response essentially follows it. This differs significantly from previous results for B{sub 4}C and Al{sub 2}O{sub 3}. The strength of the material increases by about 50% at stresses of 50-75 GPa before falling off somewhat as the phase transformation is approached. Thus, the strength behavior of SiC in planar impact experiments could be characterized as metal-like in character. The previously reported phase transformation at {approx}105 GPa was readily detected by the reshock technique, but it initially eluded detection with traditional shock experiments. This illustrates the utility of the reshock technique for identifying phase transformations. The transformation in SiC was found to occur at about 104 GPa with an associated volume change of about 9%.