Publications

Publications / Conference Poster

High Strain Rate Tensile Response of A572 and 4140 Steel

Sanborn, Brett S.; Song, Bo S.; Thompson, Andrew D.; Reece, Blake D.; Attaway, Stephen W.

Steel grades such as A572 and AISI 4140 are often used for applications where high rate or impact loading may occur. A572 is a hot-rolled carbon steel that is used where a high strength to weight ratio is desired. A grade such as AISI 4140 offers decent corrosion resistance due to higher chromium and molybdenum content and is commonly used in firearm parts, pressurized gas tubes, and structural tubing for roll cages. In these scenarios, the material may undergo high rate loading. Thus, material properties including failure and fracture response at relevant loading rates must be understood so that numerical simulations of impact events accurately capture the deformation and failure/fracture behavior of the involved materials. In this study, the high strain rate tensile response of A572 and 4140 steel are investigated. An increase in yield strength of approximately 28% was observed for 4140 steel when comparing 0.001 s-1 strain rate to 3000 s-1 experiments. A572 showed an increase in yield strength of approximately 52% when the strain rate increased from quasi-static to 2750 s-1. Effects on true stress and strain at failure for the two materials are also discussed.