Publications
Detailed investigation of solute mixing in pipe joints through high speed photography
Investigation of turbulent mixing in pipe joints has been a topic of recent research interest. These investigations have relied on experimental results with downstream sensors to determine the bulk characteristics of mixing in pipe joints. High fidelity computational fluid dynamics models have also been employed to examine the fine scale physics of the mixing within the joint geometry. To date, high resolution imaging of experimental conditions within the pipe joint has not been reported. Here, we introduce high speed photography as a tool to accomplish this goal. Cross joints with four pipes coming together in a single junction are the focus of this investigation. All pipes entering the junction are the same diameter and made of clear PVC. The cross joint was milled from clear acrylic material to allow for high resolution imaging of the mixing processes within the joint. Two pipes carry water into the joint, one with clear water and the other inlet with water containing dye and a salt tracer. Two outlet pipes are carry water away from the joint. A high-speed digital camera was used to image mixing within the joint at an imaging rate of 30 Hz. Each grey-scale (8-bit) image is 1280 x 1024 pixels in a roughly 17.8 x 14.5 cm image containing the cross joint. The pixel size is approximately 0.13 x 0.14 mm. Four experiments using the clear cross-joint have been visualized. The Reynolds number (Re) for the tracer inlet pipe is held constant at 1500, while a different Re in the clear inlet pipe is used for each experiment. The Re value in the outlets are held equal to each other at the average Re of the inlets. Re values in the clear inlet pipe values are: 500, 1000, 2000 and 5000. Visual examination of the images provides information on the mixing behavior including tracer transport along the walls of the pipe, transient variation in the amount of tracer entering each outlet, the sharpness of the clear-tracer interface and variation in the concentration of the tracer throughout the joint geometry. A sharp tracer-clear interface is visible for the clear inlet Re values of 500, 1000 and 2000, but decays to a broad gradual transition zone at a clear inlet Re of 5000. There are no visible instabilities in the clear-tracer interface at the lowest clear water Re (500), but regular periodic instabilities occur for the Re=1000 experiment and these become irregular, but still periodic at clear inlet Re = 2000 and then lose all regular structure in the Re = 5000 experiment. High speed photography applied to clear pipe joints with the necessary image processing can provide qualitative and quantitative insights into mixing processes. A limitation of this approach is that it provides two-dimensional images of a three-dimensional process. ©ASCE 2009.