Publications
Coupling of a bladed hub to the tower of the Ampair 600 Wind Turbine using the transmission simulator method
This paper presents an example of the transmission simulator method of experimental dynamic substructuring combining two substructures of the Substructures Focus Group's test bed, the Ampair 600 Wind Turbine. The two substructures of interest are the hub-and-blade assembly and the tower assembly that remains after the hub is removed. The hub-and-blade substructure was developed from elastic modes of a free-free test of the hub and blades, and rigid body modes were constructed from measured mass properties. Elastic and rigid body modes were extracted from experimental data for the tower substructure. A bladeless hub was attached to the tower to serve as the transmission simulator for this substructure. Modes up to the second bending mode of the blades and tower were extracted. Substructuring calculations were then performed using the transmission simulator method, and a model of the full test bed was derived. The combined model was compared to truth data from a test on the full turbine. © The Society for Experimental Mechanics, Inc. 2014.