Publications
Comparing late-cycle autoignition stability for single- and two-stage ignition fuels in HCCI engines
The characteristics of autoignition after top-dead-center (TDC) for both single- and two-stage ignition fuels have been investigated in a homogeneous charge compression ignition (HCCI) engine. The single-stage ignition fuel was iso-octane and the two-stage ignition fuel was PRF80 (80% iso-octane and 20% n-heptane). The results show that the heat-release rate and pressure-rise rate both decrease as the combustion is retarded later into the early expansion stroke. This is an advantage for high-load HCCI operation. However, for both fuel-types, cycle-to-cycle variations of the ignition and combustion phasing increase with combustion-phasing retard. Also, the cycle-to-cycle variations are higher for iso-octane compared to PRF80. These observations can be explained by considering the magnitude of random temperature fluctuation and the temperature-rise rate just prior to thermal run-away. Furthermore, too much combustionphasing retard leads to the appearance of partial-burn or misfire cycles, but the responses of the two fuels are quite different. The different behaviors can be explained by considering the thermal and chemical state of the residual exhaust gases that are recycled from one cycle to the next. The data indicate that a partialburn cycle with iso-octane produces residuals that increase the reactivity of the following cycle. However, for the already more reactive PRF80 fuel, the partial-burn products present in the residuals do not increase the reactivity enough to overcome the retarding effect of cool residual gases.