Cubit 15.7 User Documentation
The following activity demonstrates the basics of using CUBIT to generate and mesh a geometry. By following these steps, you will become familiar with the basics of the command-line and GUI interfaces without stopping for detailed explanations. All the commands introduced in this tutorial are documented in subsequent chapters on this manual.
Here are a few tips for the examples in the tutorial:
cubit> <Your commands go here>
If you do not have the Graphical User Interface (GUI) version of CUBIT, follow the steps in the right column below, otherwise, proceed through the steps on the left:
GUI | CL | |
Overview | Overview | |
Step 1 | Step 1 | Beginning Execution |
Step 2 | Step 2 | Creating the Brick |
Step 3 | Step 3 | Creating the Cylinder |
Step 4 | Step 4 | Adjusting the Graphics Display |
Step 5 | Step 5 | Forming the Hole |
Step 6 | Step 6 | Setting Interval Sizes |
Step 7 | Step 7 | Surface Meshing |
Step 8 | Step 8 | Volume Meshing |
Step 9 | Step 9 | Inspecting the Model |
Step 10 | Step 10 | Defining Boundary Conditions |
Step 11 | Step 11 | Exporting the Mesh |
ITEM Tutorial - A tutorial on the new ITEM wizard.
Power Tools GUI Tutorial - A tutorial on geometry decomposition and cleanup using the Power Tools on the new CUBIT GUI.
Decomposition Tutorial - A series of webcutting hints and suggestions for creating sweepable volumes on various models.
Geometry Cleanup Process Flow - A flowchart on geometry cleanup and defeaturing.